Viale Vicenza, 14
36063 Marostica VI - Italy
www.vimar.com
49400927C0 02 1911
By-alarm
01728
Caution:
The passive infrared sensor generates a positive pulse on entering a
detection sector and generates a negative pulse on leaving it; then, depending on
the chosen configuration, an alarm is generated:
a) upon entering a detection sector.
b) upon entering and exiting a detection sector.
c) when crossing one detection sector and entering the next one.
d) when crossing any of at least two detection sectors
INSTALLING THE DETECTOR
• Install the device at a height of 2 to 2.4 m.
• Do not install the detector in the vicinity of metal objects and devices that generate
radio frequencies such as televisions, computers, routers, hot spots, etc.
The installation procedure is as follows:
1. Configure the detector (see paragraph 9.2 of the radio interface installer manual
01729).
2. Acquire the detector on the radio interface 01729.
3. Secure the detector, provisionally, in the desired location.
4. Run a communication test to ensure proper communication between the detec-
tor and the radio interface 01729. If the test is successful, verified with the red
and green LEDs on the detector lighting up, secure it permanently or, on the
contrary, reposition it and perform a new test.
N.B.: Considering the powers involved and the interferences present in the field
it is possible that even the smallest movements of the device may significantly
improve or worsen the transmission quality.
It is also important to perform periodic maintenance on the devices to prevent
or detect any possible external interference.
INSTALLATION RULES
• Installation should be carried out by qualified personnel in compliance with the
current regulations regarding the installation of electrical equipment in the country
where the products are installed.
• The detector should be installed at a height of 2-2.4 m off the floor.
REGULATORY COMPLIANCE
RED directive.
Standards EN 60950-1, EN 50130-4, EN 61000-6-3, EN 301 489-3, EN 300 220-2,
EN 62479.
Vimar SpA declares that the radio equipment complies with Directive 2014/53/EU.
The full text of the EU declaration of conformity is on the product sheet available at
the following Internet address: www.vimar.com.
REACH (EU) Regulation no. 1907/2006 – Art.33. The product may contain traces
of lead.
INSTALLING THE JOINT.
1. On the back of the detector there are the two seats (indicated by the arrows)
for the pins of the joint.
2. The joint must be fixed in such a way that the two pins (indicated by arrows)
adhere tightly to the seats of point 1.
3. Joint inserted.
4. Finally, secure the joint with the fixing screw.
01728
MADE IN IT
AL
Y
Battery
:
3V
–
CR123A lithium
V
imar SpA V
iale V
icenza 14
36060 Mar
ostica VI Italy
WEEE - Information for users
If the crossed-out bin symbol appears on the equipment or packaging, this means the product must not be
included with other general waste at the end of its working life. The user must take the worn product to a sorted
waste center, or return it to the retailer when purchasing a new one. Products for disposal can be consigned free
of charge (without any new purchase obligation) to retailers with a sales area of at least 400 m
2
, if they measure
less than 25 cm. An efficient sorted waste collection for the environmentally friendly disposal of the used device,
or its subsequent recycling, helps avoid the potential negative effects on the environment and people’s health,
and encourages the re-use and/or recycling of the construction materials.