Setting AUTO Flush mode via the sensor window
Proceed as follows to set AUTO Flush mode via the sensor window:
1.
Put the system in Service mode (switch off the power for at least 15 s then switch it back on).
2.
Wait for calibration to finish.
The LED briefly lights up then goes out.
3.
Hold your hand in front of the sensor window (approx. 1 cm away) for 5 s in total.
The LED lights up briefly after 5 s.
4.
Remove your hand from the sensor window.
The LED flashes once: AUTO Flush mode is enabled and is working in SINGLE mode.
The LED flashes twice: AUTO Flush mode is enabled and is working in DUAL mode.
The LED flashes three times: AUTO Flush mode is disabled.
Important
Repeat this procedure until the system is in the desired mode.
Setting AUTO Flush mode via the app
Proceed as follows to set AUTO Flush mode via the app:
1.
Establish a Bluetooth connection between the Pr WC controller and the app.
2.
Select your desired AUTO FLush mode (OFF / SINGLE / DUAL) in the app.
3.
Press Apply to transmit the setting to the Pr WC controller.
Depending on your selection, AUTO Flush mode is either enabled (in SINGLE or DUAL mode)
or disabled (OFF).
EN
M.VILLEROY-BOCH.COM // V 0.6 // 23.10.2020 // 921100D7
47
Summary of Contents for 922311RE
Page 259: ......
