Villager VLN 185, Original Instruction, Page: 32 / 111

13
Warnings: Do not stare directly at the laser beam, do not deliberately aim the beam at
personnel and ensure that it is not directed towards the eye of a person for longer than
0.25 s.
When you make the line of the cut on the work piece, the laser line generator can help
you get better alignment.
Turn on: Press the laser generator switch (4), the laser generator (7) works.
Turn off: Press the switch again.
1.
Make sure line of the cut on the work piece.
2. Adjust the angle of cut as required
3. Plug in the machine and start the motor
4. When the blade is at its maximum speed (approximately 2 seconds), place the saw
on the work-piece.
5. Switch on the laser generator from the laser aperture using the laser generator
switch (4).
6. Align the beam with the mark on the work-piece and slowly push the saw forward
using both hands, keeping the red light beam on the mark.
7. Switch off the laser beam when completion of the cut.
OPERATION
General cutting
1.
When starting, always hold the saw handle with one hand and the auxiliary handle
(6) with the other hand. Never force the saw but maintain a light and continuous
pressure after completing the cut allow the saw to come to a complete stop. When
cutting is interrupted, resume cutting by allowing the blade to reach full speed and
then reentering the cut slowly.
2. When cutting across the grain, the fibers of the wood have a tendency to lift and
tear, moving the saw slowly minimizes this effect.
Pocket cutting
1.
Disconnect the plug from the power supply before making any adjustments. Set
the depth adjustment based on the thickness of the line drawing for the cut .raise
the lower guard by using the lift lever.
2. With the blade barely above the material to be cut, start the saw and allow the
blade to come to full speed. Gradually lower the blade unto the material to be cut
using the front end of the shoe as a pivot point. When the blade starts cutting,
release the lower guard.