Villager VLN 185, Original Instruction, Page: 27 / 111

8
d) Do not operate the power tool when stationary. It is not suitable for operation with
a saw table.
e) When performing plunge cuts which are not rightangled, secure the guide plate of
the saw so that it will not shift sideways.In the event of a sideways shift, the saw
blade may become jammed, which could lead to kickback.
f) Do not use HSS saw blades. Such saw blades can easily break.
g) Do not saw any ferrous metals. Hot chips may ignite the dust extractor.
h) Always wait until the power tool has come to a complete stop before placing it
down. The application tool can jam and cause you to lose control of the power
tool.
i) Hold the power tool firmly with both hands and make sure you have a stable
footing. The power tool can be more securely guided with both hands.
j) Only use saw blades the maximum permitted speed of which is higher than the no-
load speed of the power tool.
k) Pull the plug out of the socket before carrying out any work on the power tool.
l) Wear protective gloves when fitting the saw blade. Danger of injury when touching
the saw blade.
m) Only use saw blades that match the specifications given in this operating manual
and that are tested and marked in accordance with EN 847-1.
n) The permitted speed of the application tool must be at least equal to the
maximum speed marked on the power tool. If accessories run faster than their
rated speed, they may break and fly off.
o) Do not use abrasive wheels as the application tool under any circumstances.
p) Choose the saw blade suited to the material you want to work on.
q) Use only saw blades whose diameter matches the characteristic given in this user
manual.
r) Make sure that the blade doesn’t overheat during cutting.
DANGER! KEEP HANDS AWAY FROM CUTTING AREA!
Keep hands away from the blade. Never place hands infront or behind the path of the
blade while cutting. Keep your second hand on the auxiliary handle or motor housing.
If both hands are holding the saw, they can not be cut by the blade).
• SUPPORT LARGE PANELS. Large panels must be supported to minimize the risk of
blade pinching and kickback.
•
ADJUSTMENTS. Before cutting, be sure the depth and bevel adjustments are tight.