Villager
VLN 0805 (GB)
9
ASSEMBLING
WARNING! Always make sure the power tool is isolated from the power supply before
fitting any attachment
ASSEMBLING THE TOOLS TO BE USED
Place the tool you intend to use into the tool holder and do not allow it to go back! Pull
the hexagonal housing back to the limiter and keep it in that position. Push the bit with
a turning motion up to the limiter in the housing. When you release the housing, the
tool will be locked in place by itself.
REMOVING THE TOOLS
Pull the hexagonal housing back and take the bit out of it.
SWITCHING ON/OFF
To start the power tool, press the on/off switch and do not release the pressure off the
switch.
To switch the power tool off, release the on/off switch. You can control the speed at any
time by controlling the pressure on the on/off switch.
Light pressure on the on/off switch results in low speed, and conversely
–
increased
pressure results in high speed.
SELECTING THE PROGRAMME
–
DRILLING, IMPACT DRILLING AND CHISELING
WARNING!
Always make sure the power tool is isolated from the power supply before
fitting any attachment. The switch can be activated only when the motor has come to a
complete stop. Otherwise, the power tool may be damaged.