10
Surface Burner Adjustments (Open Top Burners)
To gain access to the surface burner adjustments:
1. Remove the grates, bowls, and grate supports.
2. Locate the air shutter “A” and loosen the screw “B” that holds the air shutter in place.
3. Remove the drip tray, allowing your work space to adjust the orifice hood “C”.
4. Replace grate support and burner bowls (this allows for correct air flow, as in normal use).
5. Light each burner by rotating the burner valve shaft “D” to high position.
6. With a proper flame height, adjust the air shutter “A” to obtain a blue flame with no yellow tipping that sits on the
burner at the burner ports.
(a) open the air shutter gap to eliminate yellow tipping.
(b) close the air shutter gap to prevent a noisy flame that lifts off the burner.
7. Turn the surface burners off.
8. Replace the drip tray.
9. Tighten the air shutter screw “B”.
10. Replace the grate support, bowls, and grates.
11. Turn the lighted burners to the low flame setting.
12. Insert a narrow flat-blade screwdriver into the hollow shaft of the surface burner valve and engage the slotted low
flame adjustment screw. The low flame should be a small flame that comes just to the top edge of the burner.
Rotate the adjusting screw clockwise to low th flame or counter clockwise to increase the flame. Turn the burn off
and relight several times, turning to the low position. The low flame should light at every port each time. Readjust
as needed.
1 1/2”
(3.8 cm)
3/8” (.95 cm)
Flame Height
A - Air Shutter
B - Air Shutter Set Screw
C - Orifice
D - Burner Valve Shaft
E - Adjusting Screw
Surface Burner Adjustment (Sealed Top Burners)
1. Turn the lighted burners to the low flame setting. Remove the knob.
2. Insert a narrow flat-blade screwdriver into the hollow shaft of the surface burner valve located behind the control knob
and engage the slotted low flame adjustment screw. The low flame should be a small flame that comes just to the
top edge of the burner. Rotate the adjusting screw clockwise to lower the flame or counter-clockwise to increase the
flame. Turn the burner off and relight several times, turning to the low position. The low flame should light at every
port each time. Readjust as needed.
Flathead
screwdriver
Surface burner valve
(behind control knob)
Flame adjustment
screw
Flame Height