6
D3 Downdraft Ventilators
viking range corporation
prepare tHe DoWnDraFt
Exterior Blower Installation
The downdraft is shipped without a blower. Purchase a Model
VEDV900 Exterior Blower and mount the
10" discharge plate
to the downdraft as follows:
1. Place the downdraft on its back on a table of flat work surface.
2. Remove the
4 nuts
and
2 clamp channels
.
3. Remove
2 screws
and the
gear motor cover
.
4. Carefully position the10" discharge plate under the
bottom
flange
of the downdraft.
5. Connect
motor plug
.
6. Replace the gear motor cover and 2 sheet metal screws.
7. Replace the 2 clamp channels and start the 4 nuts, do not
tighten.
8. Slide blower left of right to desired position. Use
cover plate
(supplied) to close up any open space.
9. Tighten 4 nuts to secure top of blower. Use
additional screws
(supplied) through bottom flange to secure bottom of discharge
plate.
NUTS
COVER
PLATE
CLAMP
CHANNELS
SCREWS
GEARMOTOR
COVER
MOTOR
PLUG
10" ROUND
DISCHARGE
PLATE
ADDITIONAL
SCREWS
BOTTOM
FLANGE
cUt coUntertop opening
All Units
1. Measure and cut the countertop opening for your width of
cooktop and downdraft.
Cooktop Width & Model
30" RDECU206
36" RDECU266
45" RDECU256
30" RDGSU200
36" RDGSU260
For use with Downdraft Models
RDIPR101RSS
RDIPR161RSS
RDIPR151RSS
Cutout Dimensions
A
29-1/8"
34-7/8"
42-7/8"
B
20-5/8"
20-5/8"
20-5/8"
C
27"
33"
42"
D
2-1/4"
2-1/4"
2-1/4"
E
1-1/16"
15/16"
7/16"
F
1-1/16"
15/16"
7/16"
A
C
B
D
F
E
BLOWER MODEL
DIMENSIONS
VIDV500
18.25" x 18.214" x 7.569"
VEDV900 28.25" x 24.75" x 7.16"
VEDV1200 22" x 30.828" x 12.724"
