7
WATER CONNECTION
The garden hose fitting, compression nut, and sleeve are located in the literature packet. The water filtration system is
shipped in the crisper drawer.
1.
Flush air and impurities from water line by turning on water supply and running a pint or more of water into a
bucket.
2.
Remove plastic cap from water valve fitting. Slide copper tubing through brass nut, and brass sleeve. Connect
brass nut on copper tubing to garden hose fitting. Connect garden hose fitting to water valve inlet port. Confirm
copper tubing is secure by pulling on copper tubing.
3.
Turn on water supply to refrigerator and check for leaks. Turn off water supply to refrigerator and correct any leaks.
Repeat this process until no leaks exist. Completely turn on water supply to refrigerator.
4. Verify drain pain is installed and aligned.
•Drain pan must be pushed past and over initial stopping point.
5.
Replace lower access panel with the air vents positioned at the top. Kitchen flooring must allow the lower access
panel to be removed.
6. After 24 hours checks for leaks. If unit is leaking, correct leaks. Repeat this process until no leaks are found.
DOOR STOP ADJUSTMENT
1. Remove center grill blade from the top air grill.
2.
Remove top air grill by removing (4) 1/4” screws with a magnetic
screw driver. Pull assembly forward.
3.
Open refrigerator door so door stop arm and shoulder screw are
accessible. Shoulder screws should be in 110
o
door opening
position.
4.
Remove shoulder screw and place shoulder screw in the 90
o
or
120
o
door opening position.
HINGE ADJUSTMENT
Verify proper door alignment. Only the top hinge is adjustable.
1. Remove the center grill blade from the top air grill.
2.
Remove top air grill by removing (4) 1/4” screws with a
magnetic screw driver. Pull assembly forward.
3. Loosen the (4) top hinge screws.
4. Align refrigerator door by lifting.
5. Tighten screws.
120
o
position
110
o
position
90
o
position
Door Stop Arm
Top Hinge
Top Hinge
Screws
