17
16
1
Measur
ement (A)
Measur
ement (A)
Me
as
ure
me
nt
(A
)
+1/4”
+1
/4
”
(.64 cm)
(.6
4 c
m)
Measur
ement (A)
+1/4”
(.64 cm)
7-3/16”
7-3
/16
”
(18.3 cm)
(18.3
cm
)
7-3/16”
(18.3 cm)
2
Measure from floor to bottom
of the anti-tip opening located on the back of range.
This will be measurement (A).
Locate anti-tip bracket on rear wall with the top left corner at
measurement (A) plus 1/4” (.64 cm) from the floor and 22-1/4” (56.5 cm)
from where the right side of range (facing range) is to be located.
1
Note: Refer to electrical and gas
requirements section for proper
installation information.
3
Mark and drill holes where bracket will be located.
4
Attach bracket with
mounting hardware provided.
Connect gas and electrical. Before placing appliance in operation,
always check for gas leaks. This must be performed by your
dealer, a qualified licensed plumber, or gas service company.
Leveling/Adjustments/Alignments
(cont.)
Connecting Gas & Electric
WARNING
TIPPING HAZARD
To reduce the risk of property
damage or personal injury;
install anti-tipping device
provided in accordance with
the installation instructions
in this document. Device
must be engaged properly to
prevent product from tipping
over.
7
Set the high corner of range so that the top of side trim is
3/8” (0.95 cm) above countertop. Level range to high corner.
DANGER
GAS LEAK HAZARD
To avoid risk of personal injury
or death; leak testing of the
appliance must be conducted
according to the manufacturer’s
instructions. Before placing appliance in
operation, always check for gas leaks
with soapy water solution.
• DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.
Anti-tip Device Installation
Anti-tip Device Installation
(cont.)
