background image

7

Dimensions

6

Specifications

Note: 

Clearances from non-combustible materials are not part of the ANSI Z21.1 scope and not certified by

CSA. Clearances to non-combustible materials must be approved by the authority having jurisdiction.
Minimum clearances from adjacent combustible construction:
  Below cooking surface (36” [91.4 cm] and below)

• Sides - 0”
•  Top grate support - 36” (91.4 cm)

Above cooking surface (above 36” [91.4 cm])

•  Sides - 6” (15.2 cm)
•  Within 6” (15.2 cm) side clearance, wall cabinets no deeper than 13” (33.0 cm) must be minimum 18” 

(45.7 cm) above cooking surface

•  Wall cabinets directly above product must be a minimum of 42” (106.7 cm) above cooking surface
• Rear - 0” with 6  ” backguard or high shelf; 0” with island trim and non-combustible rear wall;
• 6” (15.2 cm) with island trim and combustible rear wall

Gas 30” W. Range

Description

RVGR

Overall width

29-7/8” (75.9 cm)

Overall height

To top of side trim - 35-7/8” (91.1 cm) min. 37” (94.0 cm) max.

Legs adjust - 1-1/8” (2.9 cm)

Overall depth
from rear

To front of side panel - 25” (63.5 cm) 

To front of door - 25-3/4” (65.4 cm)

To front of control panel - 27-1/8” (68.9 cm)

To end of knobs - 29” (73.7 cm)

Additions to Overall
Height

To top of island trim - add 0” (0.0 cm)

To top of backguard - add 6” (15.2 cm)

To top of high shelf - add 18-3/16” (46.2 cm)

Gas Requirements

Shipped standard for Natural gas, field convert with LP conversion kit included with each unit;

accepts standard residential 1/2” (1.3 cm) ID gas service line

Gas Manifold Pressure

Natural 5.0” W.C.P./ Liquid Propane L/P 10.0” W.C.P.

Electrical

Requirements

120VAC/60 Hz; 4 ft. (121.9 cm), 3-wire cord with grounded 

3-prong plug attached to unit

Max Amp Usage

0.74 amps

Surface Burner Rating 
Natural/LP

Left front
Left rear
Center
Right rear
Right front

18,000 BTU Nat/15,800 BTU LP/Propane (5.3 kW Nat/4.8 kW LP/Propane)

8,000 BTU Nat/7,200 BTU LP/Propane (2.3 kW Nat/1.9 kW LP/Propane)
9,000 BTU Nat/8,300 BTU LP/Propane (2.7 kW Nat/2.4 kW LP/Propane)

12,000 BTU Nat/10,800 BTU LP/Propane (3.5 kW Nat/3.1 kW LP/Propane)
18,000 BTU Nat/15,800 BTU LP/Propane (5.0 kW Nat/4.5 kW LP/Propane)

Oven Interior Width

23” (58.4 cm)

Oven Interior Height

16-1/8” (40.9 cm)

Oven Interior Depth

Overall - 18-3/4” (47.6 cm)

AHAM - 15-3/8” (39.2 cm)

Oven Volume
Overall
AHAM

4.0 cu. ft.
3.3 cu. ft.

Approximate 
shipping weight 

410 lbs. 

(184.5 kg)

29-7/8”

(75.9 cm)

35-7/8”

(91.1 cm) min.

to

37”

(94

.0 cm) max.

RVGR

35-7/8”

(91.1 cm) min.

to

37”

(94 cm) max.

25-3/4”

 

(65.4 cm)

45”

 

(114.3 cm)

19-1/4”

(48.9 cm)

24”

 

(61.0 cm)

25”

 

(63.5 cm)

29”

 

(73.7 cm)

6”

(15.2 cm)

25”

 

(63.5 cm)

27-1/8”

 

(68.9 cm)

Note: 

Units shown with standard 6” backguard.

Summary of Contents for RVGR330













Reviews: