Disassembly
©2013 Viking Preferred Service
35
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
4. Pull the sensor from the liner until the sensor
connector protrudes into the oven cavity.
5. Apply side pressure to the sensor connector to
secure the connector against the opening in the oven
liner.
6. While maintaining side pressure on the connector,
disconnect the old sensor and connect the new
sensor.
NOTE:
When reinstalling the oven sensor, it may be
helpful to insert a small screwdriver or awl into
the connector and push the wiring and connector
into place.
7. Install two screws that attach the sensor to the back
of the oven liner.
Broil Element Removal
1. Remove oven door (see Door Assembly Removal).
2. Remove four screws that hold front bracket and broil
assembly to the oven cavity.
3. Carefully remove the broil assembly from the rear
bracket.
4. Pull four connectors through the oven cavity wall.
5. Mark and disconnect the four wires from the broil
assembly.
6. Reverse procedure for installation.
Bake Element Removal
1. Remove oven door (see Door Assembly Removal).
2. Remove the two screws that hold the bake element
access panel to the oven frame.
