17
Note:
Refer to “Electrical & Gas
Requirements” section for proper
installation information.
Connect gas and electrical. Before placing appliance in
operation, always check for gas leaks. This must be
performed by your dealer, a qualified licensed plumber,
or gas service company.
Connecting Gas & Electrical (30”W.)
DANGER
Gas leak hazard.
To avoid risk of personal injury
or death; leak testing of the
appliance must be conducted
according to the manufacturer’s
instructions. Before placing appliance in
operation, always check for gas leaks
with soapy water solution.
• DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.
WARNING
Electrical shock hazard.
To avoid the risk of electrical
shock, personal injury or death;
verify your appliance has been
properly grounded in accordance with
local codes or in absence of codes, with
the National Electrical Code (NEC).
ANSI/NFPA 70-latest edition.
1
16
2
1
2
3
2
2
1
Open door completely. Place pin in pin hole.
Note:
Two pins included.
Remove hinge trim screws. Take off hinge trim.
4
5
Close until pins stop door.
Lift door up and out.
Note:
Do not lift door using handle.
NOTICE
DO NOT
use the handle or oven door to
lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit.
DO NOT
lift or carry the door
by the handle.
Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.
Installation (30”W.)
1
Remove wooden brace on front of pallet.
Door Removal (30”W.)
Summary of Contents for F20518A
Page 16: ...31 30...
