Viking Custom Front DFUD042, Manual

Page: 12 / 34

REMOVING THE TOE
KICK BRACKETS AND
GUARD PLATE:
(This may only be
necessary if a hardware
installation kit was used.)
To remove the toe kick
brackets, pull the gray
tabs towards the middle
of the dishwasher. Then,
pull straight out on the
brackets.
There are six screws that
hold the guard plate in
place, two on the
upper/underneath side
and four on the front. To
remove the guard plate,
remove the six screws
holding the guard plate.
Grip the bottom of the guard late and pull it toward you to remove it. You can now
access the inlet valve and electrical connection.
The dishwasher comes with two white plastic slides for the
rear legs to protect the kitchen floor from being damaged when
you slide the unit into place. The slides snap onto the rear
legs.
Adjust the feet of the dishwasher with a ½” wrench to fit the
opening. The dishwasher may have a maximum inclination of 2
degrees without affecting its performance When the legs are
adjusted, tighten the locking nuts to the base pan.
11