Viking Custom Front DFUD042, Manual

Page: 10 / 34

INSTALLATION
WATER SUPPLY: Water
pressure for the water supply
should be minimum 18 to 176 psi.
The water inlet valve is on the
right rear of the machine.
The dishwasher should preferably
be connected to a hot water supply
(2). If cold water supply is used,
the washing times will be longer.
(See Cycle Data page # )
It’s important that the water supply line and shut-off valve have a sufficient flow volume,
at least 3 gallons (12 liters) per minute must be able to pass through the line.
ELECTRICAL CONNECTIONS:
The dishwasher comes with a 6’
(1.8cm) electrical cord for 110-120
volts, 15/20 supply. This cord
should be plugged into the 110-120
volt outlet under the sink. If the cord
is not long enough or if a hard wire
installation is needed, see illustration
below.
9