0.875" Diameter
Knockout
Mounting Ring (included)
AES-2000
The rough-in box
should be framed
into the wall.
Hinge
(8) Screws (included) for mounting
the ring to the rough-in box.
(3) Screws (included) for mounting
the AES-2000 to the ring.
VIKING
©
Hudson, WI
LETTERS
NAMES
CALL/HANG-UP
EZ
TM
HELP
VOLUME
TTY
Steel Rough-In Box (included)
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
A. Flush Mount Style (AES-2000F)
The
AES-2000F
comes with a steel rough-in box and a mounting ring. The rough-in box is meant to be framed into
the wall. Make sure the outer edge of the box is within 1/4 inch of the finished surface of the wall, but not protruding
past the surface level. Knockouts are provided in the box to accommodate conduit entrance from the sides.
12.25"
9.75"
1.25"
0.45"
3.625"
7.25"
1.25"
2.5"
1.25"
0.45"
1.26"
4.87"
9.74"
(8) 0.187"
Diameter Holes
0.875" Diameter Knockout
0.875" Diameter
Knockout
Bottom View (same as Top
View minus Knockout)
Right View (same as
Left View minus Knockout)
Front View of Steel Rough-In Box
1.
After the wall is finished, the mounting ring can be screwed to the rough-in box.
2.
Once the mounting ring is secure, the front panel of the
AES-2000S
can be fastened to the ring using the 3 screws
provided by aligning the hinge with the three holes on the right side of the frame.
Note:
Make sure the key lock is in the open position.
4.
Insert the screws and tighten the nuts firmly.
Note:
Be careful not to damage the foam gasket around the back edge of the panel.
