TOPSIDE CONTROL INSTRUCTIONS
OPERATION
INSTRUCTIONS VS502
(Royale ETS, Regal ETS, Legacy, Legend, Heritage & Tradition)
VS502 System
Pump 2 Controls Secondary
Pump, On and Off
Heat On Indicator Light
Controls Low Speed/High
Speed Pump
Turns Light ,-On/Off
Displays Temperature and
Diagnostic Messages
Sets Water Temperature
INITIAL START-UP
When your spa is first activated, it will go into a
Priming mode, indi-cated by “Pr”. The Priming mode
will last for less than 5 minutes. Then, the spa will
begin to heat and maintain the water temperature in
the Standard mode indicated by “St”.
TEMPERATURE (26°C – 40°C)
The start up temperature is set at 37°C. The last
temperature is constantly displayed on the LCD.
NOTE:
The last spa temperature displayed is current only
when the pump has been running for at least 2 minutes.
Press the “Temp” button to display the temperature
previously set. The set temperature flashes on the
display. Pressing the “Temp” button a second time,
while it is still flashing, will cause the set temperature
to increase or decrease depending on what direction
was last chosen. Each press to follow will change
the set temperature in the same direc-tion. If the
opposite direction is desired, release the pad and let
the display revert to the actual water temperature.
Press the button to dis-play the set temperature,
and press again to make the temperature change
in the desired direction. After
three seconds
, the
LCD will stop flashing and display the current spa
temperature.
12
