Viking Range C4, Use & Care / Installation Manual

Page: 3 / 6

5 4
B Be effo orre e IIn nssttaalllliin ng g Y Yo ou urr C C4 4 O Ou uttd do oo orr C Co oo okke err
After unpacking the cooker, the dome will need to be removed before
installing on a cart.
To remove the dome:
1. Open the cooker dome.
2. Remove the plastic protective caps from the top of the hinge
cylinders located on both sides of the unit.
3. Unsnap the top section of both cylinders from the ball studs on the
dome.
4. Close the cooker dome and remove the two (2) screws and nuts,
(one set on each side), on the outside of the canopy hinge. (See
Figure 2) This will allow you to use the dome hinge as a handle
when lifting up on the dome
NOTE: Occasionally the screws around the edge of the canopy may
loosen with use. Periodically check the screws and tighten if needed
with the provided allen wrench.
Top of hinge
cylinder
Plastic
cap
Plastic
cap
Figure 1
Screws on
dome hinge
Dome hinge
which can be
used as a handle
when removing
canopy
Figure 2
To replace the dome:
1. Place the dome on the cooker.
2. Open the dome. Slightly compress the cylinder and snap onto the
ball studs on the dome.
3. Replace the plastic protective caps.
Ball
studs