3
CREEPER MODE TO WORKBENCH MODE
1. Release the lock from the wider set of legs and turn the legs outward.
Then release the lock from the narrower set of legs and turn the legs
outward.
NOTE: You must follow this order when opening the legs. Otherwise
you cannot open the legs.
2. Pull each leg out and push hinge until it locks in place.
3. Turn the product over. Press the pin on each leg, then pull each leg
down until the pin clicks out again.
CAUTION: Make sure the pin on each leg clicks out before using the
product. Failure to do so may result in the legs retracting during use.
Pin out
Pin pushed in
1. Press the pin on each leg, then push in each leg.
2. Open the four latches on the sides (two locks per side).
3. Remove the panel, turn it over so that the anti-slip work platform
surface is face up, and place it back onto the platform. Fasten all four
latches.
CHANGING MODES
WORKBENCH MODE TO WORK PLATFORM MODE
EN