PACKAGING CONTENTS
The packaging contains:
– power unit,
– bar,
– chain,
– bar cover,
– bag containing equipment and documents.
The machine is supplied with
the bar and chain dismantled and the oil tank
empty.
Unpacking and complet-
ing the assembly should be done on a flat and
stable surface, with enough space for machi-
ne handling and its packaging, always making
use of suitable equipment.
Disposal of the packaging should be done in
accordance with the local regulations in force.
BAR AND CHAIN MOUNTING
Always wear heavy-duty
gloves when handling the bar and chain.
Mount the bar and chain very carefully so as
not to impair the safety and efficiency of the m-
achine. If in doubt, contact your dealer.
Before fitting the bar, make sure the chain brake is
not engaged; this is done by pulling the front hand
guard right back towards the body of the machine.
Make sure the machine is
not plugged into the mains socket.
• MACHINES WITH STANDARD
CHAIN TENSION ADJUSTER
–
N
nscrew
the
nut
(1)
and
remove
the
guard
to
get
to
the
drive
sprocket
and
the
point
where
the
bar
is
fitted
(Fig.
1).
– Mount the chain in the right direction on the bar.
If the tip of the bar has a nose sprocket, make
sure the drive links are correctly inserted in the
sprocket rims (Fig. 2).
WARNING!
WARNING!
WARNING!
IMPORTANT
– Mount the bar (2) by inserting the stud bolt in the
groove and push it towards the back of the ma-
chine body and wind the chain around the drive
sprocket (Fig. 3).
– Check that the chain tension adjuster pin (3) is fit-
ted properly in the hole on the bar (Fig. 4); if it is-
n’t, turn the chain tension adjuster screw (4) us-
ing a screwdriver until the pin is completely
inserted (Fig. 5).
– Fit the guard back on without tightening the nut
(1).
– Turn the chain tension adjuster screw (4) to ad-
just the chain tension (Fig. 5).
– Raise
the
bar
and
tighten
the
guard
nut
(1)
se-
curely
using
the
supplied
wrench
(Fig.
6).
4. MACHINE ASSEMBLY
EN
21
