(Fig. 1)
(2)
(3)
(4)
(5)
(1)
(Fi.g 2)
ViGOR GmbH
•
;
Am Langen Siepen 13-15 • 42857 Remscheid • GERMANY
[
+49 (0) 21 91 / 97 95 •
\
+49 (0) 21 91 / 97 96 00 •
]
^
vigor-equipment.com
XXX
• In case of leakages or other malfunctions, disconnect the device immediately from the
compressed air supply and repair the source of defect.
• Do not use quick-release couplings directly at the tool. There must be a pressure hose of at
least 20 cm length between the tool and the quick-release coupling.
• Replace operating tools like adapters only when the air supplying tube is disconnected.
• Before oiling or replacing operating tools like adapters etc., always disconnect the pneu-
matic tool from the compressed air supply.
• Make sure that the operating tools always are in perfect condition.
• Only use the appropriate tools for the relevant devices.
• Permanent vibrations may cause damage to health.
• Pay attention to a safe hold.
5. Design and Function
Operating Instructions for brake calliper systems
with locking device for hand brakes
• Loosen the brake calliper and swivel it to the
side.
• Remove the brake pads.
• Please make sure that there is enough space
in the fluid reservoir for the admission of the
brake fluid flowing back into the fluid reservoir
when turning back the brake piston.
• Choose an appropriate adapter and fix it to
the magnetic adapter (fig. 1).
• Connect the tool to the compressed air supply.
NOTE: Make sure that the pressure does not exceed 8 bar!
• Press the release button (2) and use the operating lever (3) in order
to move the spindle (5) forward or backward to insert the tool into
the brake calliper.
• Press the button (4) and the operating lever (3) to reset/rotate the
brake piston. (fig. 2)
• After turning the piston backwards, press the button (2) and use
the operating lever (3) in order to pull the spindle (5) backwards to
remove the tool from the brake calliper (fig. 3)
• It is absolutely necessary to consider the regulations of the manufacturer.
Operating instructions for brake calliper systems without
locking device for hand brakes
• Fix the suitable adapter to the basic appliance and insert
the tool into the brake calliper.
• Close up the spindle in order to set back the piston into its
original position.
• Remove the tool, install the brake calliper with the brake
pads and check the brake fluid level as well as the brak-
ing effect.
