![background image](http://html.mh-extra.com/html/viglen/vig615m/vig615m_manual_1022717026.webp)
V1.0
VIG615M Motherboard Manual
25
Note:
If you install two IDE devices on the same cable, you must configure the drives
separately to master/slave mode by setting jumpers.
Serial ATA Connector: SATA1 ~ SATA4
This connector is a high-speed Serial ATA interface port. Each connector can
connect to one Serial ATA device.
Figure 10:
Serial ATA Connector
Note:
Please do not fold the serial ATA cable into 90-degree angle. Otherwise, data loss
may occur during transmission.
Fan Power Connectors: CPUFAN1, SYSFAN1~2
The fan power connectors support system cooling fan with +12V. When connecting
the wire to the connectors, always note that the red wire is the positive and should
be connected to the +12V; the black wire is Ground and should be connected to
GND. If the motherboard has a System Hardware Monitor chipset on-board, you
must use a specially designed fan with speed sensor to take advantage of the CPU
fan.
Figure 11:
Fan Power Connectors
Note:
CPUFAN1/SYSFAN1/SYSFAN2 supports fan control. Fan speeds are controlled
automatically according to the actual CPU temperature.