V1.0
VIG615M Motherboard Manual
22
Table 6:
Clear CMOS Jumper Settings
Function
Jumper
(JP1)
Configuration
Save
CMOS
(Default)
1-2
The BIOS uses current configuration information and passwords for
booting.
Clear
2-3
Turn off the system and unplug the power cord. Move the jumper from
pins 1-2 (default) to pins 2-3 for about 5~10 seconds. Then move the
jumper back to pins 1-2.
NOTE:
Except when clearing the rtc ram, never remove the jumper on JP1 default
position. Removing the jumper will cause system boot failures.
There is no jumper setting for configuring the processor speed or bus frequency.
Motherboard Connectors
There are connectors on the motherboard for FAN, IDE, Power supply, CD audio,
Floppy, IDE, & Front Panel Connectors. The location and/or details of these
connections are shown below.
Front Panel Connectors
The following are all connectors situated along the front edge of the motherboard.
They are often connected to buttons and LED’s situated on the front panel of the
case.
JFP1
JFP2
Figure 5:
Front Panel Connectors
Table 7:
Front Panel Connector Pin Definition (JFP1)
