Vig550B Motherboard Manual – Ver 1.0
36
Table 10:
Problems and Suggestions
(Continued)
What happens
What to do
Hard drive light does
not go on when drive
is in use or is tested
by POST
Make sure the power and signal cables for the drive are properly installed.
Make sure the front panel connector is securely attached to the system
board headers.
Check that the drive is properly configured and enabled in Setup.
Check the drive manufacturer's manual for proper configuration for remote
hard disk drive activity.
Power-on light does
not go on
If the system is operating normally, check the connector between the
system board and the front panel. If OK, the light may be defective.
Prompt doesn't
appear after system
boots
It’s probably switched off.
A serious fault may have occurred consult your dealer service department
/ Technical Support.
Setup, can't enter
If you can't enter Setup to make changes, check the switch that disables
entry into Setup (Chapter 2). If the switch is set to allow entry into Setup,
you might need to clear CMOS RAM to the default values and reconfigure
the system in Setup.
System halts before
completing POST
This indicates a fatal system error that requires immediate service
attention. Note the screen display and write down any beep code emitted.
Provide this information to your dealer service department / Technical
Support.
