3
Typical Install Location of System
Installation
1. Remove all packing material from the Reservoir area and make sure the parts list is complete.
2. Place the Guardian Humidification System in the bottom of your cabinet.
3. Insert the small end of the power cord through a hole in your cabinet and plug it directly into the power jack on the
front of the Control Module of your System.
4. Placement of Sensor:
Reliance models: A Sensor bar has been preinstalled beneath the cabinet drawer
o
Peel off the backing paper from attached Velcro strip on preinstalled Sensor bar
All other models: Determine a suitable location for placement of the Sensor, preferably 2/3rds up from the
back panel or side wall (As close to horizontal center on the back panel as possible).
o
Peel off the backing paper from the loop-style Velcro strips and attach the strip to the inside of the
cabinet at the desired location for placement of the Sensor
o
Attach the Sensor to the adhesive back of Velcro strip you applied
5. Extra support for the Sensor can be gained using the included Wire Anchors and Zip Ties.
6.
Simply
plug your humidor into a surge protector
that is attached to a grounded outlet
. The digital read out
and red time-to-fill LED will illuminate within six seconds. Make sure that the white mesh Wicking Filter is
sitting vertically upright in your water Reservoir.
