Vigilant 80DSB, Quick Start Manual

Page: 4 / 4

Installation information
Detector Base Sounder cabling
Wiring notes

All wiring must comply with local installation regulations and local fire system design requirements.

Ensure all conductors are free of earths.

Verify correct wiring and wiring polarity before connecting the devices to the addressable loop.
Remote LED out, wired only if a remote indicator is
required
R
Not wired M
Must not be wired
L2
Positive line in and out
L1
Optional Remote Indicator
Fig. 4: Detector Base Sounder cabling
M
R
Loop Negative
Loop Negative
L2
L
L1
Loop Positive
Loop Positive
Negative line in and out
L
Cabling
Function Contact
Fig. 3: Detector Base Sounder dimensions
1 – Temporary park plunger
2 – Address flag holder
114
2
1
Fig. 2: Fitting the locking pin
Fig. 1: Mounting the Detector Base Sounder
A-CON
Fig 3 contains the dimensions of the Detector Base
Sounder.
These units either fit directly to the ceiling or to an optional ceiling adaptor. See Fig 1.
See Fig 2 for fitting the locking pin. To remove a detector from a base with a locking pin, complete these steps:
1
Insert a suitable tool into the access hole to depress the locking pin in the detector cover.
2 Rotate the detector to remove.
These units can be used with the Ceiling Tile Adapter (CTA) kit (517.050.060) by using the CTA Adaptor Plate, CTA-AP
(517.050.058).
Use the knock outs for the cabling as required.
Dimensions Mounting
45
50 70
For ordering, please contact Johnson Controls Customer Service in Melbourne on 1300 725 688 or fdp.customerservice.anz@jci.com
For application or sales enquiries, please contact your local Johnson Controls sales representative.
For technical support or technical training enquiries, contact Johnson Controls Technical Support Centre on 1300 552 559 in Australia or 09 635-0617 in New Zealand.
Further information on the extensive range of fire detection products available from Johnson Controls is available on the Fireplace website at http://vigilant-fire.com.au.
Aust r alia office: Level 3, 95 Coventry Street, Southbank, VIC 3006, Australia
New Zealand office: 17 Mary Muller Drive Hillsborough PO Box 19-545 Woolston Christchurch 8241
120.515.396.ANZ V1 © 2020 Johnson Controls. All rights reserved. All specifications and other information shown were current as of document revision date and are subject to change
without notice.