TECHNICAL SPECIFICATIONS
Power supply: 220-240V ~ 50/60 Hz
Power: 1 000 W
Protection class: II
Power supply cable length – 150 cm
Weight brutto: 2,1 kg
Weight netto: 1,65 kg
Product dimensions without packaging: 6,5 x 40,5 x 6,5 cm
Product dimensions with packaging: 24 x 25,7 x 13 cm
BEFORE FIRST USE
Unpack the device from the box and ensure that the packing material does not get into the hands of
children (there is a risk of choking on plastic bags). All extensions that come into direct contact with food
should be washed thoroughly with hot water before using for the first time. Then rinse them thoroughly
with drinking water and wipe dry. Before connecting the device, compare the parameters listed on the
nameplate with the parameters of your power supply. This data must match!
CAUTION
• Operation of the appliance must be interrupted for 2 minutes after 2 minutes of continuous operation.
Failure to observe this rule could result in damage!
• The time with no load should not exceed 15 seconds. However, it is strongly recommended that you do
not let the device without load at all.
• The blender blades are very sharp. When handling them, be careful to avoid possible injury.
MOTOR UNIT
This device has two speed levels:
1) 1. Speed mode (No. 2). This level can be continuously adjusted by means of a continuous speed
controller (No. 1).
1) Turbo function (No. 3). When you press this button, the unit switches to maximum power.
MIXING VESSEL
The package includes a mixing vessel with a capacity of 600 ml.
• The vessel is suitable for measuring and blending of ingredients
• This vessel is intended only for short-term contact with food, therefore do not store any food in it for
more than two hours!
• The blending vessel is not suitable for use in a microwave oven.
USING THE APPLIANCE WITH WHIPPING OR KNEADING ATTACHMENTS
1) Put the kneading bits (No. 8, 9) with a slight pressure to the gearbox (No. 7) until you hear a click. Then,
click on the gear unit to the engine unit until you hear a click. Install gearboxes against the buttons on the unit.
Remove the gearbox by pressing the release buttons on the drive unit. Remove the whipping or kneading
attachments with a slight pull from the gear unit.
str
16
Summary of Contents for TM4V1
Page 32: ......
