6
Front and Side View of Monitor
Installation of Monitor
This monitor is intended to be mounted in and used where NEMA 4 and NEMA 12 type
enclosures are employed. When mounted properly, the monitor meets or exceeds the sealing
requirements set forth in the NEMA 4 and NEMA 12 specifications. The monitor uses “U”-shaped clips
and a special gasket to achieve the proper seal.
To install the monitor, make a cutout per the diagram below in one of the walls of your NEMA
enclosure. Enclosures made of heavier gauge metal work better in that they won’t deform or bend as
easily when the monitor’s sealing gasket is compressed. Next hold the monitor in place while you install
the mounting clips. Tighten the clips in a cross pattern. This will help to develop an even pressure on the
sealing gasket. Tighten the clips to the point were the back of the monitor’s front bezel just begins to
contact the front of the NEMA enclosure. DO NOT OVER TIGHTEN AS DAMAGE CAN RESULT IN THE
MONITOR CAUSING LOSS OF SEALING INTEGRITY.
SEL UP
I
O
SEL DN
INC
DEC
SET
UP
OFF
ON
POWER
MENU
Viewtronix
18.51"
3.35"
15.70"
