1
USER NOTICE
Please read this operating manual carefully before operation.
WARNING
1. Do not use or store in a place with explosives, a strong magnetic field or
combustible gas.
2. Unauthorized dismantling or modification of this borescope voids the
warranty.
3. Make sure the power is turned off before putting the instrument into the
carrying case.
4. Never touch the lens/LED module during or immediately after use. Contact
may cause burns.
5. If smoke or abnormal noise is detected, stop using and turn off the bore-
scope immediately.
6. Do not look directly look at the light from the end of the insertion tube. It
is extremely bright and can cause eye damage.
7. If any abnormality is noticed during operation, stop using and turn off the
borescope immediately.
ATTENTION
1. Only use this borescope within the approved operating
temperature range.
2.
DO NOT over-torque, bend, twist, or fold the insertion tube. Doing so
could damage the articulation control wire assemblies and/or electrical
wiring.
3.
Only use the power adapter provided by Viewtech.
4.
DO NOT yank or attempt to forcefully remove the insertion tube if it
becomes stuck inside the equipment being borescoped. When extracting
the insertion tube from the inspection area:
a. Be sure that the bending section (distal tip of the insertion tube)
is straight. Use the joystick to remove any angle before attempting
removal.
b. If the insertion tube becomes stuck during removal, gently rotate
the joystick until it becomes loose again.
5.
After use, center the joystick in order to straighten the bending section
prior to storage. The borescope should always be stored with the bending
section straight (do not force the bending section with your fingers –
always use the joystick to adjust and straighten the bending angle.)
I
