Installation
231
ViewSonic
Pro9500
2.3 Installing the second projector (Set
B
)
2.
With Set
B
placed on Set
A
, push
the elevator buttons of Set
B
to
extend the elevator feet without
lifting Set
B
. Make sure the ele-
vator feet reach the bottom of the
stack pockets on Set
A
.
NOTE
• It is necessary to keep Set
B
slightly away from Set
A
except for the
heel portion to prevent the two projectors from resonating due to the sound
output from the built-in speakers.
• If Set
B
is tilt further, the image of Set
B
may not be superimposed to the
image of Set
A
.
• If the elevator feet of Set
A
are used, make sure the tilt angle for both sets is
within 12 degrees from the level line.
CAUTION
►Be careful when
stacking the two projectors, the
projector on top may slide down.
Connecting projectors
To use Intellectual Stack, connect an RS-232C cross cable between the
CONTROL
port of Set
A
and Set
B
.
3.
Rotate the elevator feet of Set
B
twice in the counterclockwise direction and leave a gap of about 1 mm be-
tween the protrusion at the bottom of Set
B
and the top of Set
A
as shown in
the figure.
Stacking the projectors
1.
Place Set
B
on Set
A
when stacking the two projectors. Make sure the heel
on the bottom of Set
B
is inserted into the corresponding pocket on the top of
Set
A
.
Summary of Contents for PRO9500
Page 112: ...107 ViewSonic Pro9500 unit mm ...
Page 289: ......
