32
Wireless connection
To connect to the projector wirelessly, you have to plug a ViewSonic wireless dongle
(optional) to the USB Type A connector on the projector, and then only a few OSD
configuration steps are required.
1. Make sure the projector is turned on.
2. Press
MENU/EXIT
on the projector or
Menu
on the remote control and then press
/ until the
Network
menu is highlighted.
3. Highlight
Wireless LAN
and press
ENTER
on the projector or
Enter
on the remote
control.
4. Make sure the
Status
is
Connect
.
5. Make sure the
SSID
information is displayed.
6. In
AP
mode, you need to use your computer’s wireless connection utility to search
the projector’s SSID and connect to it. Then you can search the projector with
vsPresenter. To use
Infrastructure
mode, you should connect both your computer
and projector to the same AP router and make connections with the IP address.
About AP and Infrastructure modes
In AP mode, you need to use your computer's wireless connection utility to search for
the
projector's SSID and connect to it. Then you can search for the projector with
vsPresenter.
In Infrastructure mode, you should connect both your computer and projector to the
same
AP router and make connections with the IP address.
The following diagram describes how to access the Internet in AP and Infrastructure
modes.
Important
•
If you need more information about AP and Infrastructure modes, please refer to user
documentations for Wireless Routers which are usually available on 3C stores.
ViewSonic wireless dongle
(AP mode)
Internet
(Infrastructure mode)
Internet
http://www.pureglare.com.au
Summary of Contents for Pro8520HD
Page 68: ...http www pureglare com au ...