ViewSonic NMP-570W, User Manual

Page: 8 / 21

3
2. Configuring the NMP-570/NMP-570w Media Player
2.1. System connections
1. Attach a video cable (either VGA or HDMI) to your monitor.
When using the VGA connection , your monitor should support XGA
(1024x768) resolution or greater. For audio output, you will also need
to connect a stereo RCA cable from the NMP-570/NMP-570w to your
monitor.
When using an
HDMI connection, audio is sent along with video over the
HDMI cable, so no additional cables are required.
Reminder: If you do not see anything on screen, check your monitor
video input mode.
2. Attach the AC power adapter to power on the unit. Shortly afterwards, the
following progress bar will be displayed on your monitor:
3. Player boot process takes approximately 90 seconds to complete. The
player will indicate that it is ready for content sync via the USB port or, if
content has been loaded, begin playback immediately.
After performing the initial setup as
outlined above, the player will boot
into the “Open Standard Media Player”
screen. Plug in a USB keyboard to
enter configuration menus .
If you have already loaded media
contents into the player, contents will
90 seconds
Troubleshooting Tips Troubleshooting Tips