38
Active VGA Out
Once the COMPUTER IN and COMPUTER OUT jacks have been properly connected
to the corresponding devices, select
ON
to generate VGA signal output. The projector
will only receive output signals via Computer In 1.
Active Audio Out
When the AUDIO IN jack is correctly connected to a device, select
ON
to output audio
signals.
Adjusting the sound
The sound adjusents made as below will have an effect on the projector speaker(s).
Please check that you have made a correct connection to the projector audio input /
output jacks. See
“Connection”
for details.
Adjustments in Audio Mode
1. Open the OSD menu and enter
Basic
>
Audio Settings
>
Audio Mode
menu.
2. Press
/
to select the primary Audio Mode.
If available, you may press the [Audio Mode] on the remote control to select the primary Audio mode.
Mute
1. Open the OSD menu and enter
Basic
>
Audio Settings
>
Mute
menu.
2. Press
/
and select
ON
.
If available, you may press the
button on the remote control to switch the projector audio
ON or OFF.
Adjusting the sound level
1. Open the OSD menu and enter
Basic
>
Audio Settings
>
Volume
menu.
2. Press
/
to select the desired volume.
If available, you may press the
button on the remote control to adjust speaker volume of
the projector.
Switch off the projector
1. Press the
Power button. A confirmation message will be displayed on screen. The
message will disappear if you do not respond within a few seconds.
2. Press the Power button again.
3. Disconnect the power cord from the wall socket if the projector will not be used in an
extended period of time.
Summary of Contents for LS810
Page 81: ......
