61
RS-232 Protocol
This document describes the hardware interface spec and software protocols of the
RS-232 interface communication between ViewSonic LFD and a PC or other control
units with RS-232 protocol.
The protocol contains three command sections:
•
Set-Function
•
Get-Function
•
Remote control pass-through mode
NOTE:
Below, “PC” represents all the control units that can send or receive the
RS-232 protocol command.
Description
RS-232 Hardware Specification
ViewSonic LFD communication port on the rear side:
1.
Connector type: DSUB 9-Pin Male (female or 3.5 mm barrel connector)
2.
Use of crossover (null modem) cable for connection
3.
Pin Assignment:
Male DSUB 9-Pin
(preferred)
Female DSUB 9-Pin
Pin # Signal
Remark
1
NC
2
RXD
Input to Display
3
TXD
Output from Display
4
NC
5
GND
6
NC
7
NC
8
NC
9
NC
frame
GND
3.5 mm barrel
connector (alternative
for limited space)
Item
Signal
Remark
Tip
TXD
Output from Display
Ring
RXD
Input to Display
Sleeve
GND
Summary of Contents for CDE12
