ViewSat VS PRO, User Manual

Page: 11 / 26

The channel searching process takes a few
minutes.
It shows the searched TV channels on the
left and Radio channels on the right.
When the Progress bar reaches 100%,
searching process is done.
Push OK key to save and exit.
※
Tip : Exit key finishes searching anytime
with saving channel info searched by that
time.
7.2.4. LNB Power
Select LNB Power menu in Installation
menu.
Set LNB Power ON or OFF
(Available only for Splitter LNB)
7.2.5. Motor Setting
Select Motor Setting menu in Installation
menu.
If you have a DiSEqC 1.2 or USALS
motorized system, then you can take
advantage of the Motor control function.
You can drive your motor by using this
menu. Adjust antenna direction using the
left/right keys(
◀∙▶
) with checking the
signal strength.
Move Motor
Recalculation
East / West limit
Save current limit
Remove current limits
Motor central position
1.3(USALS) only
My Longitude
My Latitude
Goto the Position
: Move to East or West direction while pushing the left or right key.
: Apply the calibrated value to all Satellites.
: Set the limit position.
: Store the current position of the motor for the selected satellite.
: Remove the previous limit information.
: Move to center.
: Input a value of longitude by numeric keys and set West or East by
the left/right keys(
◀
·
▶
).
: Input a value of longitude by numeric keys and set West or East by
the left/right keys(
◀
·
▶
).
: Move the motor to the position as the input value.
7.2.6. Edit TP List
Select Edit TP List menu in Installation
menu.
You can select a satellite and edit the TP of
that.
Select a TP by using the up/down keys
(
▲·▼
) and push OK key.
Edit the TP data by using numeric keys.
* Green: Add New TP
* key will pop up a menu for selecting
satellite.
7.2.7. Update Software
You can upload your software and
channel data from Receiver to PC or
USB memory through a serial cable or a
USB cable.
Please contact the distributor. They will
provide you with useful information about
this.
19 20