VIEWONHOME VOH1001, Installation And User Manual

Page: 10 / 21

19 18
Wireless Door / Window Contact
Features
signals to the control panel when the
Thanks to the tamper switch, any t to remove the cover of the Door / Window Contact
will trigger the alarm.
Design
Magnet
Transmitter
LED indicator
PCB Layout
LED working indicator
Zone setting
AAA 1.5V Battery
AAA 1.5V Battery x 1
Tamper switch
LED
Blinks once : the door or window is open and the sends a signal to the control panel.
Blinks quickly: Low power indica the eries must be replaced.
Register the detector in the alarm system
Press the at the back of the control panel to enter the mode. Then
separate the magnet from the er.
To check if the registr is complete, arm the system and separate the magnet from the
again by opening the door or window on which it is installed. If the siren rings out,
the regis is successful.
- Open the case and remove the ery strip.
- Mount the sensor on the door and the magnet on the
door frame.
- Make sure the magnet is placed above the er.
- Mount the magnet max. 1 cm away from the
and secure the and magnet with double-sided
tape or screws.
- Avoid the sensor in areas with a large amount of
metal or electrical wiring such as a furnace or room.
Power supply
current
≤ 30 uA
Alarm current
≤ 15 mA
Tr distance
≤80 m (in open area)
Radio-frequency
433 MHz (±75 KHz)
Housing material
ABS
Oper temperature
-10°C~55°C
humidity
≤80% (non-condensing)
T dimensions (LxWxH)
60 x 45 x 18 mm
Magnet dimensions (LxWxH)
45 x 19 x 17,5 mm
The door/window contact can be installed on doors, windows, and any other objucts that open
and close. The sensor sends signals to the control panel when the magnet is separated from the