25
1.2 Precautions
Safety
1. Power Source: The unit should be connected
to power supply only of the type described in the
operating instructions or as marked on the unit.
2. The unit is designed for negative terminal of the
battery which is connected to the vehicle metal.
Please confirmit before installation.
3. Do not allow the speaker wires to be shorted
together when the unit is switched on. Otherwise it
may overload or burn out the power amplifier.
4. Do not install the detachable panel before
connecting the wire.
5. The protective case is to safely keep the front
panel(see the photo).
Environment
1. Do not use this unit when water and moisture is
near it.
2. If moisture forms inside the Lens, it may not
operate properly. To correct this problem, wait about
one hour for the moisture to evaporate.
3. If the car interior is extremely hot, do not use the
player until the car has been driven for a while to cool
off the interior.
1.3 Maintenance and Cleaning of Discs
Disc Maintenance
1. To keep the disc clean, andle the disc by its edge,
do not touch the disc surface of the play side.
2. Do not stick paper or tape on the disc. If there is
glue (or analog) on the disc surface, must wipe it up
before using.
3. Do not expose the disc to direct sunlight, or
nearby heat sources such as caliduct, or leave it in
a car parked in direct sunlight where there can be a
considerable rise in temperature.
4. Put the disc inside disc case to keep temperature
after finishing playback.
Disc Cleaning
1. Before playing, wipe the disc with a clean lint. wipe
the disc outwards from the disc center.
2.Do not use petrel, thinner. commercially cleaner or
anti-static spray can damage the unit
1.4 Battery Information of the Remote
Control
Replace Battery in the Remote Control
1.Before using the remote control for the first time,
pull the insulating sheet out of the remote control as
the direction indicated by the arrow.(see fig.1)
2.Press the movable block hold as the direction
indicated by theA arrow (See fig.2), then pull the
battery holder out of the remote control as the
direction indicated by the B arrow(see fig.2).
3.Replace the old battery by a new battery with (+)
polarity side upward. (See fig.3).
4.Insert the battery holder to the original position in
remote control. (See fig.3).
Note about the Battery of the Remote
Control
1. Improper use of battery may cause overheating or
explosion. so that Result in injury or fire .
2.Battery leakage may cause damage to the remote
control (Battery Life: 6 months with normal use in
normal room temperature).
3.Do not short the battery.
4.Do not throw the battery into the fire.
5.To avoid the risk of accident, keep the battery out of
reach of children.
