12
Default display
1.
"Menu"
2.
"Central Heating"
3. Select the required heating circuit.
4.
"Op mode"
Fig. 6
5. Select the required operating program:
■
è
for heating mode
■
â
for economy mode
■
Þ
for party mode
An operating program with a highlighted frame is
already enabled.
Note
and are only shown when the heating is ON.
Note
Tapping
è
again shuts down heating mode.
Time program
Further information can be found in chapter
"Terminology" in the appendix.
Setting a time program
The times at which the heating circuit delivers central
heating with standard or reduced room temperature
depends on the setting of the switching times for the
relevant day (4 possible time phases).
■
If one or more time phases are set, central heating
with standard room temperature is active during
those times.
■
If no time phases are set, central heating is carried
out to the reduced room temperature for the whole
day.
■
For central heating, up to 4 changes between stand-
ard and reduced room temperature can be program-
med per day (4 time phases).
■
For weekdays,
time phase
!
has been factory-set
from 06:00 to 22:00 h. During this time your home is
heated to the standard room temperature.
■
You can set
individual
switching times for each
weekday.
When setting switching times, note that your heating
system requires some time to heat the interior to the
required temperature.
Note
For the period between the specified switching times,
the relevant heating circuit is regulated to the standard
room temperature.
Setting switching times
Default display
1.
"Menu"
2.
"Central Heating"
3. Select the required heating circuit.
Central heating
Operating program
(cont.)
5778 774 GB
Summary of Contents for Vitotrol 350-C
Page 42: ...42 5778 774 GB...
Page 43: ...43 5778 774 GB...
