38
5833 275 - 04
Vitotrans 300 Installation, Operating and Service
Installation
Commissioning
Devices Required for Commissioning:
- PC Laptop with Ethernet port and
web browser application
- CAT5 / RJ45 network cable
1. Using the Network and Sharing
Center, set Internet Protocol
Version 4 (TCP/IPv4) to a static IP
address of 192.168.0.XX (use any
other than 50, 100, 101, 102).
2. Plug the network cable into the
RJ45 port located inside the
control panel of the Vitotrans 300.
(see page 24 for diagram of
control panel layout)
3. Open the web browser application
and type 192.168.0.100 into the
address
bar.
4. A login screen will appear, enter
the following information:
Username: manufacturer
Password: vimaster
WARNING
The MANUFACTURER access level allows for changes
to be made that can alter the function of the Vitotrans
300. Making changes other than what is detailed in
these instructions may result in unwanted operation.
5. Once logged in, a menu pane on
the left side of the screen will
display the following tabs, note the
actions that can be taken:
- Home: Displays general device
information,
No Changes
can be made.
- Network:
No Changes
can be made
to any settings within
this
tab.
- BACnet: Changes can be made,
see following steps.
- Users:
No Changes
can be made to
any settings within this tab.
- System: Changes can be made,
see
following steps.
- BLE Room Devices: Not Applicable
