3
6167196 GB
For your safety (cont.)
Installation work
Safety instructions
Danger
Contact with live components can
result in severe injuries. Some
components remain live even after
the power supply has been
switched off. Wait at least 4 minutes
for the voltage to discharge before
removing the appliance covers.
Safety instructions for working on the appliance
Danger
Hot surfaces and fluids can cause
burns.
■
Switch off the appliance and
allow it to cool down before
carrying out any maintenance
work.
■
Do not touch hot surfaces on the
appliance, fittings or pipes.
■
Switch off the power supply, e.g. at
the separate fuse or a mains isolator.
■
Safeguard the power supply against
reconnection.
■
Check that it is no longer live.
■
Do not make any modifications to the
water or electrical installations.
■
Do not make any structural
modifications to the appliance.
Maintenance work
■
Only install the appliance on a suitably
stable wall with the fixing materials
provided.
■
Do not make any structural
modifications to the appliance.
■
Install an isolator in the power cable
to provide omnipolar separation from
the mains for all active conductors,
corresponding to overvoltage
category III (3 mm) for full isolation.
The isolator must be fitted in the
permanent electrical installation, in
line with installation requirements.
We also recommend installing an
RCD (Class A) for pulsating DC (fault)
currents.
■
Connect the power cable to the
electricity supply using a fixed
connection.
Select a cable cross-section and fuse
appropriate to the output of the
appliance.
■
An appliance of protection class I
must be permanently connected to an
earth conductor.
■
Provide protection against contact
with live parts. Install covers.
