Viessmann Vitopure S6-S, Manual Book

Page: 4 / 24

4
DESKRIPSI PRODUK
DATA TEKNIS
Perangkat ini dipasang di keran air rumah. Elemen filter digunakan untuk menahan kotoran seperti endapan lumpur,
karat, dan kandungan padat di dalam air. Perangkat juga menghilangkan warna dan bau dari air. Setelah elemen
penyaring mencapai usianya, maka akan diganti dengan yang baru.
Vitopure S6-T Faucet Filter Water Purifier
Vitopure S6-T Faucet Filter Water Purifier
21
NOTES : NOTES :
MAINTENANCE AND USE
FIRST USE REPLACE FILTER ELEMENT
■
After installation, slowly turn on water mixer.
Inspect all pipe connections involved in the installation
process for water leakage.
■
.
The device is used to reduce sand, gravel, debris and other
sediments contained in water or accumulated on pipe wall.
If the water source itself contains viscous sediment, such as
silt andclay etc., it is necessary to replace filter element on a
regularly
Replace filter element
Initial use and start-up
S6-T
S6-S
■
Turn off water faucet and put outlet knob to the position
"Raw Water" or "Raw Water Sprinkler".
Unscrew the used filter element from water purifier.
Mount new filter element.
Turn on water faucet.
Turn off water faucet after it is found that water flow
is stable.
Check all pipe connections involved for water leakage and
tighten again if necessary.
When filter element is replaced, pay attention to measuring
the height and angle. No obvious stress is allowed after
connection, so as to avoid water purifier being damaged due
to stress during long-term use.
■
■
■
■
■
■
■
Turn off water mixer.
Unscrew the shower from shower hose and water mixer.
Open the upper cover of shower, take out the used filter
element, put in a new filter element and screw the upper
cover.
Connect shower to shower hose and water mixer.
Turn on water mixer. Turn off it after it is found that water
flow is stable.
Check all connections for water leakage and tighten again
if necessary.
When filter element is replaced, pay attention to measuring
the height and angle. No obvious stress is allowed after
connection, so as to avoid water purifier being damaged due
to stress during long-term use.
■
■
■
■
■
■
Mount new filter element and finish the
replacement step.
Unscrew filter element from the device
Check Tightness
When the device is used for the first time, please check all
connecting fittings to make sure there is no water leakage.
Slowly turn on the mixer knob and check whether the
drainage goes smoothly.
Do not allow water temperature to exceed 50°C when raw
water (tap water) is used.
Since carbon-contained water may flow out when water
purifier is used for the first time, please make water flow
for 60 seconds before use.
Before daily use, please make water flow for 10 seconds.
If water purifier is not used for a long time, please make
water flow for 60 seconds before use.
When filter element is installed or replaced, make sure to
turn off water mixer. Upon the completion of replacement,
please make water flow for 60 seconds to remove carbon
powder.
It is necessary to replace filter element, especially when
inflow water contains more clay or silt, it is required to
replace filter element frequently
ID
EN
Nama produk : Faucet Filter Water Purifier
Model : Vitopure S6-T
Air masuk : Air PAM
Filter : Coconut shell activated carbon filter
Kapasitas air : 83 liter/menit
Tekanan Kerja : 1.5 - 6.5 Bar
Pipa air Masuk / keluar : DN20
Temperatur Air Masuk : 1- 39 ºC