Viega MegaPress Z3 Actuator
8
3.2 Preparing the Press Tool
Placing the Viega Z3 Actuator On the Press Tool
▶
On the press tool, rotate the retaining pin
handle 180 degrees and pull it out to
open the slot for the actuator.
▶
Insert the Viega Z3 actuator into the slot
on the press tool.
▶
On the press tool, push the retaining pin
back in and rotate it 180 degrees.
NOTE! The handle on the actuator can
be removed if necessary.
3.3 Pressing
Caution!
Risk of crushing
Risk of getting your fingers and hands crushed.
■
Hold the press tool with both hands on the handle area during
pressing.
Note!
Property damage due to defective press ring
Using a defective, incorrectly sized, or worn press ring may result in an
incorrect press.
■
Before using the press rings, check them for visible defects.
■
Only use defect-free press rings of a suitable size.
Follow the instruction for use for the press tool and the MegaPress 2½"
to 4" piping system you are using.
