2.3.4
Markings on components
The press connections are marked with a coloured dot. This identifies
the SC-Contur, where the test medium would escape in the case of an
inadvertently unpressed connection.
The model is marked as follows:
n
flow direction indicator
n
noise class I pursuant to applicable regulations, see
from section: Marking on components“ on page 7
n
dimension
n
DVGW writing
n
position indicator below the handwheel
n
green dot for drinking water
2.3.5
Compatible components
The model is equipped with press connections and compatible with the
Sanpress and Sanpress Inox system.
The press connections are tested and approved pursuant to the appli‐
cable regulations with the following pipe types:
n
Stainless steel pipes (material 1.4401 / 1.4521)
– see
„Regulations from section: Compatible components“
2.3.6
Technical data
Observe the following operating conditions for the installation of the
model:
Operating temperature [T
max
]
90 °C
Operating pressure [P
max
]
1.6 MPa (16 bar)
The performance diagram shows the pressure losses (in hPa) in relation
to the volume flow and the nominal width.
Pipes
Product information
Easytop Inox slanted seat valve (free flow valve) with SC-Contur
11 from 20
