Vidicode V-Tap ISDN PRI, Manual, Page: 18 / 42

V-Tap ISDN PRI Manual EN v1.3 Okt 2018 © 2018 Vidicode 18
3.3.3 Wi-Fi settings
The Wi-Fi module in the V-Tap may not be enabled by default. To
enable, enter “FACTORY WIFI” in the App Special Flags field. After
pressing Save and log in again, the 3 Wi-Fi parameters become visible.
Once Wi-Fi is enabled, you can use your mobile phone or a laptop to
connect to the V-Tap over the air to access the settings. The following
steps must be made:
•
Search for Wi-Fi apparatus on your smartphone or laptop, the device
name “V -Tap_PRI _xxxxxx” is then shown.
•
Select it and when asked for a password, use the 12 digits MAC
address of the unit, found on the bottom of the case. The first 6
digits of the MAC are always 000349 and the last 6 digits are also
part of the Wi-Fi name.
•
Open a browser and enter the IP address 192.168.55.66. The web
login page should appear. After login with admin/admin, the
settings page appears.
The internal Wi-Fi works as an Access Point (AP) for web access, and can
connect to an external AP for the tunnel function, at the same time.
See
App Special Flags for more Wi-Fi options.
Wi-Fi Access Point
This enables or disables the internal AP mode and therefore enables
or disables the web access using Wi-Fi. The password to connect with
Wi-Fi can be changed in the FTP & Web & Wi-Fi Password field.
Wi-Fi Tunnel AP Name
Wi-Fi Tunnel AP Password
To setup a tunnel connection over Wi-Fi, the V-Tap must connect to
an external AP. In most of the cases this will be a router somewhere
in the building. The AP’s name and password must be filled in here.
The Wi-Fi module can be disabled completely by turning the Wi-Fi Access
Point option off in the settings AND the Tunnel AP fields must be left
empty. When disabled, all access must be done with a LAN cable.