66250865-EN - V 3.4 - 31/08/16
14
VK8K/6256 Series “6 wire Bus” videokit
VK8K/6256 Series - Installation handbook
Art. 6256
3.5" colour videophone
27 mm
144 mm
182 mm
Fig. 1
+V
-
1
2
V1
V2
24V
ac
0V
ac
SW1
SW2
PT3 PT2
PT1
SW1
LB
SB
LD
2A
3A
4A
5A
Fig. 2
DESCRIPTION
Surface mount videophone incorporating a 3.5” Hi-Res full colour active matrix LCD monitor specific for “6 wire” videokit (VK4K,
VRVK and VK8K range). It includes 4 buttons: “camera recall”, “open door” , “service” and “privacy”.
2 LED’s* indicate the privacy activated and open door. Programmable privacy duration and number of rings. Intercommunicating
call and door call. Adjustments: call tone volume switch (3 levels), picture hue, contrast and brightness.
* The operation of some LED’s and the functions described may require additional cabling
PUSH BUTTONS
Service push button.
Shorts the “SB” terminal to GROUND (open collector 24Vdc 100mA max) while the button remain pressed.
Camera recall button.
Pick up the handset then press the button (Press once for door/gate 1, twice for 2 and so on up to a maximum of 4
entrances): the relevant LED switches ON and the monitor switches on showing the video from the door panel. The
speech is also live and the door can be opened by pressing
.
Door-open / intercommunicating call button.
With the handset lifted and speech lines open to the entrance panel, press this button to open the door. If the termi-
nal “LD” is properly connected the relevant LED remains switched ON until the door is closed.
Intercommunication only works when the system is in stand-by condition.
Switch 4 of the SW1 dip-switch selects the type of intercommunication:
OFF
Intercommunication between two apartments - pick up the handset and press the key button to call the video-
phone(s) in the other apartment. A busy tone will signal that the other videophone is in conversation with the
door station and so cannot be called.
ON
Intercommunication between videophones in the same apartment
- pick up the handset and press the key button one, two, three or four times to call videophone with extension ad-
dress 1, 2, 3 or 4 (Set on dip-switch 2&3 of SW1).
Any intercommunicating conversation is always interrupted by an external call (i.e. External calls take priority).
Privacy ON-OFF button.
When the system is in stand-by, the pressing of this button activates (LED switched on) or disables (LED switched
off ) the “privacy” service. The service is automatically disabled when the programmed privacy time expires. When
the service is enabled the videophone does not receive calls.
