Videx IP videokit IPVK/6296 Series, Installation Handbook

Page: 7 / 76

66550062-EN - V6.0 - 31/10/21
- 7 -
IPVK/6296 Series IP videokit
IPVK/6296 Series - Installation handbook
Art. 4533
Speaker unit with built-in camera
Art. 4533X
Speaker unit with built-in camera & proximity key reader
PROGRAMMING TAGS (ONLY ART. 4533X VERSIONS)
The programming of the tags is carried out through the VIDEX IP Wizard software.
USING TAGS
Place a tag in front of the tag reader:
↪
If the tag is programmed, the external module emits two high-pitched
“beeping”
sounds and its relay is activated.
BIP BIP
↪
If the tag is not programmed, the external module emits three low-pitched
“beeping”
sounds and its relay is not
activated.
BIP BIP BIP
FACTORY DEFAULT PROCEDURE FOR ENTRANCE PANEL SUPPLIED WITH VIDEOKITS
The following procedure can be used to reset and pair the videophone and entrance panel supplied in a one apartment or two
apartment kit. Once paired the door panel will call the videophones without any further setup required. Additional setup is optional
to set device names, specific IP addresses etc. The default IP addresses are:
Entrance panel
192.168.1.180 //
Videophone 1
192.168.1.181 //
Videophone 2
192.168.1.182
4533 DOOR PANEL RESET FOR ONE OR TWO APARTMENT VIDEO KIT
The door panel is required to be open for this procedure.
1. Power down the door station;
2. Restore the power keeping pressed Call Button 1 (Bottom button on a 2 button panel
Fig. 7 ) until the (red) and (green)
led’s start flashing together ( Fig. 8 )*;
3. Press the boot loader button once (inside the panel) ( Fig. 9 ), the red LED will stop flashing while the green LED contin-
ues flashing together with the yellow LED ( Fig. 10 );
4. Press call button 1 ( Fig. 11 ) for a one way videokit otherwise press call button 2 ( Fig. 12 ) for a two way video kit;
5. When the button is released, the door panel emits one long beep for one way videokit or two long beeps for two way videokit
then reboots with the new settings.
* If the door panel is connected to the cloud, the LED will flash twice and the panel will reboot without changing your settings. In this case, the IP wizard must be used to make any changes
to the door panel settings.
Fig. 7
Keep pressed button 1
Fig. 8
Bell & Key LEDs flashing
STEEL
ALI
HIGH BRASS
MATTE
4533-0
4533-1
4533-2
Made in Italy
RELAY 1 RELAY 2 INPUTS
EXT CAMERA
POWER ETHERNET
EXPANSION
BUTTONS
RS485
C1 NO1 NC1 NO2 NC2 C2 IN1 GNDI IN2 GND +12V RX+ RX– TX+ TX–
GND
B A
V
JP1
GND
SL
Close
Open
PROG.
4533X-0
4533X-1
4533X-2
Fig. 9
Press the boot loader button (back
of the module)
Fig. 10
Speech & Key LEDs flashing
Fig. 11
One way videokit
Fig. 12
Two way videokit