66251030-EN - V2.1 - 15/06/16
3
3600 Series
Art. 3618 - Installation instructions
MENÙ 2
• When the monitor is turned ON (conversation or camera recall) press the “
” button to enter the adjustment menu.
• The OSD menu appears on the display: the top of the screen shows “menu” followed by the allowed function icons, the bottom
of the screen shows the currently selected function value on the left, the currently selected function icon in the middle and the
next function icon on the right side.
• The first adjustment is the speech volume: press as many times or hold pressed the “
” button to increase or the “
” button
to decrease the speech volume level (signalled by a beep).
• Press the “
” button to store the new value and to enter the following programming function.
• The second adjustment is the brightness: press as many times or hold pressed the “
” button to increase or the “
” button
to decrease the brightness level (signalled by a beep).
• Press the “
” button to store the new value and to enter the following programming function.
• The third function is the contrast: press as many times or hold pressed the “
” button to increase or the “
” button to de-
crease the contrast level (signalled by a beep).
• Press the “
” button to store the new value and to enter the following programming function.
• The fourth and last function is the hue: press as many times or hold pressed the “
” button to increase or the “
” button to
decrease the hue level (signalled by a beep).
• Press the “
” button to store the new value and exit the programming menu the monitor goes back to shown standard mes-
sages for conversation.
SYSTEM MODE
• To set the 890 Mode (for systems where it is used the control unit Art. 890/Art. 890N) unplug the ribbon cable from the PCB con-
nection board Art. 5980 then plug it again keeping pressed the button “
” until the related LED switches on for approx 1 second.
• To set the 4838 Mode (for systems where it is used the speaker unit Art. 4838) unplug the ribbon cable from the PCB connection
board Art. 5980 then plug it again keeping pressed the button “
” until the related LED switches on for approx 1 second.
TO SET THE VIDEO MODE
The videophone can operate with ei-
ther composite video signal (coax cable)
or balanced video signal (two wires).
Switches 1 & 2 of SW2 are used to set vid-
eo mode while switches 3 & 4 are for vid-
eo termination. When more videophone
have a pass through connection for the
video signal, you must enable the video
termination only for the last videophone.
VIDEO MODE
Switches 1,2
Mode
Coax
Balanced
75 OHM VIDEO TERMINATION
Switches 3,4
Termination
Enabled
Disabled
Art. 3618
Videophone for traditional video systems using coax video signal or balanced video signal