66251030-EN - V2.1 - 15/06/16
2
3600 Series
Art. 3618 - Installation instructions
PUSH BUTTONS
1. During a call, press this button to reject the call.
2. When the system is in stand-by, short pressing of this button enables / disables the privacy service. The relevant
LED will illuminate when the privacy service is enabled. When privacy is enabled calls will not be received.
3. When the system is in stand-by, press this button until the videophone switches on emitting a beep to enter into
the programming menu that allows to set the privacy duration, the call tone volume, the melody selection, the
number of rings and the door opening time.
4. During a conversation, press this button to enter the adjustment menu that allows to set the speech volume, the
brightness, the contrast and the hue.
5. During a conversation, press and keep pressed this button until the videophone emits a beep: the auxiliary output
is operated and the terminal “12/SB” is linked to ground for 2 seconds.
CONTROLS AND PROGRAMMING
The adjustments and settings are carried out through the two OSD menus that are described below. For video mode setup (coax or
balanced) operate the 4 way dip switch on the rear side of the videophone.
The Art. 3618 has an additional programming related to the system in which it is used: 890 Mode (for systems in which it is used the
control unit Art. 890/Art. 890N) and 4838 Mode (for systems in which it is used the speaker unit Art. 4838).
The videomonitor has two different menus for programming and adjustment functions:
1. One menu operates when the system is in stand-by and allows to set:
• The privacy duration;
• The melody volume;
• The melody type;
• The number of rings;
• The door opening time;
2. The second menu operates when the system is turned ON (during a conversation or a camera recall) and allows to set;
• Speech volume;
• Brightness;
• Contrast;
• Hue;
MENÙ 1
• When the system is in stand-by (monitor turned OFF) press and hold pressed the “
” button until the monitor switches emitting
a beep to enter the programming menu.
• TThe OSD menu appears on the display: the top of the screen shows “menu” followed by the available function icons, the bottom
of the screen shows the currently selected function value on the left, the currently selected function icon in the middle and the
next function icon on the right side.
• The first function available is the privacy duration (max 20 hours): press as many times or hold pressed the “
” button to in-
crease or the “
” button to decrease the duration of a half an hour each step (signalled by a beep).
• Press the “
” button to store the new value and to enter the following programming function.
• The second function is the melody volume: press as many times or hold pressed the “
” button to increase or the “
” button
to decrease the melody volume level (signalled by a beep).
• Press the “
” button to store the new value and to enter the following programming function.
• The third function is the melody type: press the “
” button to hear and select the previous melody or the “
” button to hear
and select the following melody.
• Press the “
” button to store the new value and to enter the following programming function.
• The fourth and last programming function is the number of rings (max 9): press as many times or hold pressed the “
” button
to increase or the “
” button to decrease the number of rings.
• Press the “
” button to store the new value and to enter the following programming function.
• The fifth programming function is the door opening time (max 99 seconds): press as many times or hold pressed the “
” but-
ton to increase or the “
” button to decrease the number of rings.
• Press the “
” button to store the new value and exit the programming menu, the monitor turns OFF .
Art. 3618
Videophone for traditional video systems using coax video signal or balanced video signal