STH-DCSG
U
SER
’
S
M
ANUAL
©
2005
V
IDERE
D
ESIGN
21
fixed in the firmware. The one changeable parameter is for 50 Hz or 60 Hz
operation (Section 3.3).
The Firmware Parameter dialog is only available after the STH-DCSG has
been opened by pulling down the
Video
item of the
Input
chooser. To
use 50 Hz operation, check the box, and then press the
Save
button. This
choice is downloaded and stored in the device, and will cause 50 Hz
operation every time the STH-DCSG is accessed. To change back to 60
Hz, uncheck the box and again save it to the device.
It is also possible to clear any calibration parameters that are saved on the
STH-DCSG firmware. If the calibration parameters are present, the Clear
Calibration button will be activated. Pressing this button will clear the
parameters. See the SVS Users’ Manual for information on saving and
loading calibration parameters on the device.
Figure 7-3 Firmware parameters dialog.
