Videotec Oucirlamp, Instruction Manual

Page: 5 / 20

EN - English - I
nstruc
tions manual
3
h h
Before assembling the illuminator, apply
Loctite 243® inside the screws holes.
Insert the
illuminator's red connector
inside the
hole and make it come out from the font part of the
housing.
Fig. 09
Use the M4 screws supplied to secure the illuminator
to the camera.
h h
Use the flat and lock washers supplied as
standard.
Fig. 10
Connect the
illuminator's red connector
to
the
electronic board's red connector .
Fig. 11
On the card there are 3 connected flat cables. Use a
felt-tip pen to mark the flat cable connected to the
connector marked with a white spot .
Fig. 05
Disconnect the 2 abreast flat cables.
Fig. 06
At this point, use a hammer and a pointed
screwdriver to break the pre-established fracture
zone on the camera group.
Fig. 07
Assemble the sunshield on the illuminator using the
M3 screws supplied.
Fig. 08