Instruc
tion manual - English - EN
13
MNVCMBA_1817_EN
7.3.9 Description of the switch board
DESCRIPTION OF THE SWITCH BOARD
Connector
Function
J1
RJ45 Ethernet Connector
J3
RJ45 Ethernet Connector
J5
RJ45 Ethernet Connector
J2
SFP connector
Tab.
4
J1
J3
J5
J2
J1
J2
J3
J5
Fig.
5
Operation of the RJ45 connectors is signalled by the
relevant two LEDs:
• Yellow LED: LED on, indicates the connection is
enabled.
• Green LED: LED on, indicates the connection speed
is 100Mbps; LED off, indicates the connection
speed is 10Mbps.
Operation of the SFP connector is signalled by the
relevant three LEDs:
• Yellow LED: LED on, indicates the connector is
enabled.
• Red LED: LED on, indicates the fibre optic signal
has pinged; LED off, indicates the fibre optic signal
has not pinged.
• Green LED: LED on, indicates the connection speed
is 100Mbps.
7.3.10 Ethernet cables connection
The switch board can manage up to 3 RJ45 ports and
is equipped with a slot for SFP modules.
Connect the Ethernet cables to ports RJ45 J1, J3, J5.
Insert the SFP module (not supplied) in Slot J2 of the
switch board (7.3.9 Description of the switch board,
page 13).
Consult the SFP module manual for the relevant
specifications.
VIDEOTEC
has tested various types of SFP
modules. For further information please
contact the VIDEOTEC service center.
Consult the installation manuals of the devices to
connect for specifications on the Ethernet cable.
